The lithium battery in the Allen-Bradley Programmable Logic Controllers (PLC) provides backup power to the processor’s memory.Should a power outage of less than 30 minutes long happen, the processor’s memory will use the battery’s backup power to retain information.Lasts from two to five years, depending on processor type and battery usage.
A red “Low Battery” light on the front of the processor indicates when the PLC battery voltage has become low and the battery needs to be replaced.
Step 1
Check the position of the PLC battery. If it is in front of the processor module, keep the PLC plugged in. If it cannot be located without removing a module from the chassis, unplug the PLC.
Step 2
Press the retainer clips at both the top and bottom of the processor module, and slide it out. If the battery is located in the front of the processor module, this step is not required.
Step 3
Inspect for damage to the battery casing or leakage of electrolyte. According to Allen-Bradley’s Guidelines for Handling Lithium Batteries, if the old battery is damaged or leaking, put the damaged battery in two polyethylene bags; add 1 oz. of calcium carbonate to the inner bag; and heat seal both bags. Contact a Allen-Bradley’s battery disposal company for proper disposal.
Step 4
Unplug the battery connector, and remove the battery from the retaining clips.
Step 5
Inspect the replacement battery to ensure that it is identical to the removed battery.
Step 6
Write the current date on the new battery with a marker. If there is no space to write the date directly on the new battery, use the labels that were provided with the new battery. In addition, place one date label on the front of the battery compartment, and write the current date on this label.
Step 7
Plug the new battery connector into the socket, and push the battery into the retaining clips.
Step 8
Slide the processor module into the chassis until the retainer clips click.
Step 9
Restore power to the PLC.
Step 10
Ensure that the “Battery Low” indicator located on the front of the processor is off.
>>>>>>>>>>>>>>
3.0V 1800mAh Replacement PLC Battery for Allen Bradley 1756-BA1